Will update with pictures, not sure about the order to take this apart. Access Clark GPX25E Forklift Repair Manual. This Clark GPX25E repair manual contains information that you need for your fork truck equipment. CLARK FORKLIFT C 40 45 50s 55s L SERVICE MANUAL. It is the forklift repair documentation and service instructions for your trucks from Clark. I think these brakes are in an oil bath so opening it up is going to be messy. Here is our PDF bundle that includes the Clark GPX25E forklift repair manual you need (PDF formats). Clark Forklift C-60 English O-205 Operator’s Manual.pdf. Clark Forklift C-60 English O-204 Operator’s Manual.pdf. Clark Forklift C CY CFY CH CHY60-80 English O-126 Operator’s Manual.pdf. Clark Forklift AGT5 English OM-552 Operator’s Manual.pdf. Parking brake cable is slack, and the arm it's connected to (which looks like it goes to a lever through the bell housing), is fully in the released position.Įdit: So my buddy came by the shop and he said it seems to feel like a brake shoe is grabbing and locking, i tend to agree with this so i got the front up in the air with our overhead hoist and put it up on blocks, took the right wheel off, and pulled the hub, started it up and the planetary drive gear spins immediately, and stops when you apply the brake, Left side is locked up, so the problem is definitely in the left brake, the open differential is putting the motion to the right since the left is locked. Clark Forklift AGT40 English OM-600 Operator’s Manual.pdf. It also has sort of an intermittent kind of drag (what would feel like a warped drum on a car) until the thing fully breaks free.Ĭould it be in the parking brake? is this a separate brake from the normal brakes? Remind you i never touched the brake pedal during these test, but in other times touching the brake pedal initially (before you actually press into the braking action) has the same effect as shifting to neutral (which is desired) and has the same result as above, shifting into neutral then back into gear. It is important for your safety and to the care of your lift truck to use the proper equipment 5. Shifted it back into N hopped off and i could push the lift forward by hand (heavy son of a gun) but when i tried to pull it backwards by hand it definitely locked up against a brake, like a ratchet? In reverse it does the same thing but when you put it in back neutral it doesn't seem to want to go forward or backwards when pushing/pulling by hand. CLARK strongly recommends that all powered industrial trucks have maintenance and inspections performed in conformance with a scheduled Planned Maintenance (PM) Program. Ok so i just got done doing some testing, during these tests i NEVER touched the brake pedal, i just shifted at idle directly into F N and R, Started the forklift up, let it idle for about 30 seconds to get all the fluids pumping, put it into F and it sorta jolts forward about an inch and then stops and you can hear the engine under load, give it a stab of the gas and it will release and start driving forward.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |